Craftsman 113.24140 Owner's Manual page 21

lubrication
The saw motor bearings have been packed at the factory
with proper lubricant and require no additional lubrication.
The following parts should be oiled occasionally with SAE
No. 20 or No. 30 engine oil.
1. Tilt screw threads and pivot nut. (First clean with
Craftsman gum & pitch remover.
ELEVATION "
SCREW
PIVOT NUT
TILT SCREW
PJVOT NUT
2. Elevation screw threads and pivot nut. (First Clean with
Craftsman gum & pitch remover.
3. Cradle bearing points.
4. Bearing points in guard assembly, miter gauge and rip
fence.
FENCE
]1_ BEARING POINTS
RECOMMENDED ACCESSORIES
ITEM CAT. NO.
Steel Base ............................. 9-22214
Tool Bench ............................. 9-1071
Solid Table Extension .................... 9-24277
Adjustable Table Extension ................. 9-2178
Combination Dado/Molding Insert .......... 9-29934
Casters ................................ 9-22201
Sawblades ........................... See Catalog
7-In. Dia. Molding Head .................... 9-3217
6-In. Dia. Dado Head ...................... 9-3249
7-In. Dia. Adjustable Dado Head ............. 9-3267
7-In. Dia. Dado Head ...................... 9-3257
Blade Stabilizers ......................... 9-4952
Miter-Gauge Stop Rods .................... 9-29924
Miter-Gauge Hold-Down Clamp .............. 9-29928
Hold-Down Set .......................... 9-3230
Taper Jig ............................... 9-3233
Universal Jig ............................ 9-3231
Sanding Wheel ........................... 9-2274
Work Light ............................. 9-2480
Work Light ............................. 9-2481
The above recommended accessories are current and were
available at the time this manual was printed.
21