Installing the VLS12000 Node into a Rack
The components of the VLS12000 Gateway are connected with 1 meter cables. Install the components
close enough in the rack to accommodate the cable lengths. HP recommends the following racking
configuration installed from bottom to top:
Figure 3 Recommended rack configuration
.
Item
Description
1
Ethernet Switch 2810 24G (1 Gb)
2
Ethernet Switch 2510 24 (100 Mb)
3
Node 0, primary node
4
Node 1, secondary node
NOTE:
If you are installing the node into a telco rack, order the appropriate option kit at the RackSolutions.com
web site: http://www.racksolutions.com/hp. Follow the instructions on the web site to install the rack
brackets.
Install the node in the rack as follows:
22
Hardware Installation