Table of Contents
Advertisement
Installation of the warming drawer.
Read these instructions completely and carefully.
Step 2—Install Warming Drawer
Slide the left corner into opening and push
power cord into the hole leading to the
outlet location. Thread the cord through as
drawer is being pushed back into the
opening.
If the outlet is installed inside the opening,
plug the cord into the outlet. Coil power
cord and install it in the clip on the right side
of the unit. Make sure the cord does not get
trapped by the drawer.
NOTE: Insure that the power cord does not
contact the hot surfaces on the bottom of
ovens, cooktops, or any other appliance.
Push the drawer back until the front flange
is flush to the cabinet front.
Open the drawer fully.
16
Drill pilot holes through the holes in the
overlapping frame, one on each corner.
Drive wood screws provided into each
corner.
Advertisement
Table of Contents
