Adjustments; Adjustments; Adjust Traction Pedal For Neutral; Adjust Traction Pedal For Forward - Toro Sand Pro 2020 Service Manual

Adjustments

Adjust Traction Pedal for Neutral

If the machine "creeps" when the traction pedal is in the
neutral position, the traction cam must be adjusted.
1. Park the machine on a level surface. Turn the en-
gine off.
2. On the SP 2020/3020, pivot seat upward and re-
move engine shield. On the SP 5020, remove three cap
screws securing side panel to the right side of machine
and remove panel.
WARNING
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 – Safety.
3. Raise one rear wheel off floor and place support
blocks under frame.
4. Loosen locknut on the adjustment cam.
WARNING
The engine must be running to perform the fi-
nal adjustment of the traction adjustment cam.
Guard against possible personal injury. Keep
hands, feet, face, and other parts of the body
away from rotating parts and hot engine parts
such as the muffler.
Adjust Traction Pedal for Forward (SP 2020/3020)
The pedal must be adjusted for forward if the jam nuts
on the control rod are loosened or if the pedal is re-
moved.
1. If the jam nuts on the control rod are loosened or the
pedal is removed, adjust pedal for forward.
2. Make sure pump is in neutral.
3. Loosen jam nuts on the control rod.
4. Press down on the rear of the pedal until the pedal
contacts the footrest.
5. Adjust jam nuts to allow for full stroke of the pump
lever in the reverse direction. The control rod must de-
flect slightly when the pedal is at full stroke.
Hydraulic System (Rev. A)
5. Start engine. Rotate adjustment cam in both direc-
tions to determine mid position of neutral span.
6. Tighten lock nut securing the adjustment cam.
7. Stop engine.
8. Remove support blocks and lower the machine.
Test drive machine to make sure it does not creep.
9. On the SP 2020/3020, install engine shield and piv-
ot seat down. On the SP 5020, secure side panel to the
right side of machine with three cap screws.
1. Lock nut
1. Jam nuts
2. Control rod
Page 4 – 28
2
1
Figure 16
2. Adjustment cam
2
3
1
Figure 17
3. Pedal
Sand Pro 2020/3020/5020