Table of Contents
Advertisement
You MUST unpmugany moad
from the generator
before starting
to prevent
permanent
damage
to any appliances.
PuHH starter grip showily until you feeHresistance,
then puHH briskHy. Return starter grip gently.
PuHH
rope with a rapid fuHH arm stroke. Let rope rewind
showily. Repeat if necessary.
Starter Grip
NOTE:
iF ENGINE OIL LEVEL IS TOO LOW, EN-
GINE WiLL NOT START. CHECK OIL LEVEL AND
ADD IF NECESSARY.
If choke controH Heveris in CLOSED position, move
Heverto OPEN position as engine warms up.
IMPORTANT:
AHHow generator to run at no Headfor 5
minutes upon each initiaHstart-up to aHHow engine and
generator to stabiHize.
STOPPmNG ENGmNE
Disconnect aHH eHectricaHHoads.
Turn engine switch to "OFF" position.
CHosefueH shut-off vaHveHocated under gas tank.
IMPORTANT:
Never store engine with fueH in tank,
indoors, or in encHosed, poorHy ventiHated areas or
where fueHfumes may reach an open flame.
CONNECTING
ELECTRICAL
LOADS
,
Let engine run and warm up for five minutes after
starting with no eHectricaHHead.
Connect Heads in the foHHowingmanner to prevent
damage to equipment:
Connect inductive Headequipment first, inductive
Heads consist of refrigerators, freezers, water
pumps, air conditioners,
or smaHH hand tooHs.
Connect the items that require the most wattage
first.
@
@
Connect the Hights next.
Voltage sensitive equipment shouHd be the Hast
equipment connected to the generator. PHug
voHtage sensitive appHiances such at TV's, VCR's,
microwaves,
ovens, computers,
and cordHess
teHephones into a UL Histed voHtage surge protec-
tor, then connect the UL HistedvoHtage surge
protector to the generator.
IMPORTANT:
You shouHd aHways add up the rated
watts of aHH Hights, tooHs and appHiances you are
powering at one time. This totaH shouHd not
exceed the rated capacity of you generator or
circuit breaker rating of the receptacHe suppHying
power.
1
Move the fueH vaHve Hever to the "OFF"
position.
FueB
Vamve
Lever
15 -- ENG
NGP670040
Advertisement
Table of Contents
