Table of Contents
Advertisement
3.
If the insert is BELOW
the table surface,
remove
the
insert
and bend
the tabs (with
pliers)
enough
to make
the insert ABOVE
the table surface.
4.
To replace insert.
Place
insert
into
insert
opening
in table
and push
toward
rear
of
saw
to engage spring
clip
and until
keyslot
in insert will drop over screw. Tighten
screw.
DO NOT TIGHTEN
SCREW TO THE POINT WHERE IT
DEFLECTS THE INSERT.
CHECKING BLADE SQUARENESS TO TABLE
IMPORTANT:
BLADE
must
be SQUARE
(90° ) to
TABLE, in order to proceed with assembly.
To check for blade squareness, refer to "BLADE
TELT, OR
SQUARENESS
OF BLADE TO TABLE"
adjustments on
page 25.
NOTE: The Combination
Square must be "TRUE"
- See
start of "Unpacking
and Checking Contents section on page
6 for checking method.
CHECKING BLADE FOR HEEL
IMPORTANT:
Saw blade MUST be parallel to miter gauge
groove.
To
check
for
parallelism,
refer
to
"HEELING
ADJUSTMENT
OR PARALLELISM
OF BAWBLADE TO
MITER GAUGE GROOVE" adjustment on page24.
CHECKING BLADE ELEVATION
Maximum depth of cut MUST NOT EXCEED TWO AND
ONE HALF
(2-1/2 INCHES. This adiustment is set at the
factory and should be checked to make sure that it has not
changed due to rough handling during shipment.
MAKE
SURE SQUARE
IS NOT
TOUCHING
TIP OF
TOOTH
\
\
With the blade up as high as it will go, measure the distance
from the top of the table to top of the highest saw tooth.
If
it is more than two and one half (2-1/2) inches, adjust it at
this time. Refer to "BLADE
ELEVATION"
adjustments
on
page 26.
ATTACHING
AND ASSEMBLING TABLE EXTENSIONS
If you received
two
Table Extensions with
your
saw
(furnished
with
Model
No.
113.296051)assemble
and
attach them at this time.
1. Position saw upside down on floor.
NOTE'. To protect
the finished surfaces of the saw and
extensions, lay e piece of heavy paper on the floor.
2, From among the loose parts find the two loose parts
bagsfor table extensions.
B Hex Head Screws 5/16-18 x 1¼ in. long
8 Lockwashers, 5/16 in. External Type
(approx. dia. of hole 5/16 in.)
8 Flat Washers (dia. of hole 11/32 in.)
8 Hex Nuts, 5116-18 (approx. dia. of hole 5/16 in.)
16 truss head screws 1/4-20 x 1
4 corner support brackets
4 corner stiffener brackets
16 Hex nut 1/4-20
16 !ockwashers, 1/4" External Type
4 Flat Washers (Dia. of hole 17/64)
3.
Install
support
corner brackets,
stiffener
corner
brackets, screws, Ioekwashers, washers, and nuts for
assembling
extensions as shown...tighten
screws
attaching extensions to tabre SNUGLY. BE SURE END
OF EXTENSIONS
ARE EVEN WITH FRONT EDGE
OF SAW.
4.
Leave saw in upside down position until you attach the
rip fence guide bars and legs,
/_e_
/
17/64 DIA. FLAT WASHER
f
FLAT WASHER
LOCKWASHER
5/16-18 x 1-1/4 SCREW
Hide quick links:
Advertisement
Table of Contents
