Craftsman 646.107391 Owner's Manual page 4

E
ALWAYS START AND STOP THE
POLISHER ON OR AGAINST THE
SURFACE.
G
After flat surfaces are covered with wax,
do sides of the car. Hold the polisher as
shown. Let the cord hang free. It is not
necessary to use a criss-cross motion on
doors and fenders.
F
Before beginning, locate the LOCK button
on the trigger switch. To lock the polisher
in ON position for ease of operation, press
the LOCK button. To release, press the
trigger switch.
Place the extension cord over your
shoulder and do flat surfaces first--hood,
trunk and roof. Cover areas quickly with
broad, sweeping strokes in a ¢riss-cross
pattern.
DO NOT press down on the polisher.
The machine's action, not pressure,
does the best job.
t
LErr =:>'_m<_,T
°° o.=}.1°_
Lq
_,',JI
,,=,_ I
4
H
Remove the wax applicator bonnet and
use it to hand-polish all hard-to-reach
surfaces; under the bumpers, around the
door handles, etc.
Throw away the wax applicator bonnet
and put a clean terrycloth bonnet on the
polisher.
J
Polish the wax in the same order it was
applied. Use long, sweeping strokes in a
criss-cross pattern. Do not press hard. Let
the polisher do the work.
4