Advertisement
TOROUE
ADJUSTMENT
KEYLESS
I_NG
CHUCK
SWITCH
TRIGGER
SCREWDRIVER
BITS
BAI"rERY
PACK
WRIST
STRAP
BATTERY PACKSHOWN
IN CHARGING STAND
REDUGHT
(LED)
CHARQ[NG
STAND
CHARGER
DIRECTION
OF ROTATION
SELECTOR
(FORWARD
REVERSE)
LEVEL
BATTERY PACK
STOOGE
8
Fig. 1
The battery pack for your tool has been shipped In a low
charge conditionto prevent possibleproblems.Therefore,
you shouldcharge it overnightpriorto use.
Note: Batterieswill not reach full charge the first time they
are charged.Allow several cycles (drillingfollowed by
recharging]for them to become fullycharged.
CHARGING BATrERY
PACK
See F-_ure I.
•
Charge battery pack only withthe chargingassembly
provided.
•
Make sure power supply Is normal household
voltage, 120 volts, 60 Hz, AC only.
•
Connect chargarto power supply.
•
Place battery pack in chargingstand. Align raisedrib
on battery pack with groove in charging stand.
See F_ure I.
•
Press down on battery packto be sum contacts on
battery pack engage propadywith contacts in charging
stand.
•
The charge indicaZor light (LED), Iocad_ed o n the
charging
stand, willlight up red and glowwhen the
charger is properlyconnected to power supply.This
light indicatesthe charger is operatingproperly.It will
remain on untilbattery pack is removedfrom charging
stand or charger is disoonneoted from power supply,
The tightonlyglowswhile battery pack is charging.
•
Note: ff chargerdoes not chargebattery pack, ratum
battery pack and charging essembly to your nearest
Sears Repair Center for electricalcheck.
•
After normalusage, 3 hoursor lessof chargingtimeis
requiredtofullyrechargebatterypack. Note: it battery
packis cornplstely discharged,6 hoursor longerof
charging time is required to fullyrechargebatterypack.
•
The battery pack willbecome slightlywarm to the
touch while charging.This is normal and does not
indicatea problem.
•
Do not place charger in an area of extreme heat or
cold. it will work best at normal roomtemperature.
•
When batteriesbecome fully charged, unplugcharger
from power supplyand remove the battery pack.
IMPORTANT
INFORMATION
FOR RECHARGING
HOT BATTERIES
When using your drill-drivercontinuously, t he batteries in
your battery pack will become hot, You shouldlet a hot
battery pack cool down for approximately30 minutes
before attemptingto recharge,
Note: This situationonlyoccurswhen continuous useof
yourdrillcausesthe batteriesto become hat. it does net
occurunder normaldmumstances,Refarto "CHARGING
BA'I'rERY PACK" for normalrechargingof batteries,ffthe
chargerdoes notchargeyourbatterypack undernormal
dmumstances,returnboth the batterypack and chargerto
your nearest Sears repairranter for electrioai check.
Advertisement
