Table of Contents
Advertisement
If the DVD/VCR does not perform properly when operated as instructed in this INSTRUCTION MANUAL,
check the player consulting the following checklist.
DVD
VCR
Mode
PROBLEM
No power.
The player does not respond to
the remote control.
VCR
Mode
PROBLEM
Timer recording is not pos-
sible.
Recording mode cannot be
engaged.
No picture or poor picture on
playback.
No picture but the audio is
OK in playback.
Playback picture is partially
noisy.
On-the-air TV programmes
cannot be seen.
Video or colour fades in and
out when making a copy of
a video tape.
TROUBLESHOOTING GUIDE
• Make sure the power plug is connected to an AC outlet.
• Make sure the power is turned on.
• Check if the power plug is connected to an AC outlet.
• Check the batteries in the remote control.
• Aim the remote control directly at the remote sensor. If necessary, remove all the obsta-
cles between the sensor and the remote.
• You have to be within 23 feet of the DVD/VCR.
• Check if the correct mode is selected. If not switch the mode by pressing the DVD or VCR
Button on the remote control.
• Make sure the timer recording is set correctly.
• Make sure the power is off.
• Make sure the DVD/VCR clock is set correctly.
• Make sure the erase-prevention tab on the tape is intact. If removed, cover the hole
after the tab with adhesive tape.
• Set your TV to the video channel.
• Fine tune your TV.
• Head cleaning is necessary, consult the nearest Authorized Service Center.
• Adjust tracking control for a better picture by using the CH Buttons (o/p) .
• Re-check the AERIAL and RF OUT connections.
• Set your TV to the TV channel correctly.
• You cannot copy a copyrighted video tape. You are experiencing copy guard protection.
CORRECTIVE ACTION
CORRECTIVE ACTION
– 48 –
EN
2C15
Advertisement
Table of Contents
