Rear-Panel Ports And Leds - Cisco 1700 Overview Manual

Rear-Panel Ports and LEDs

Rear-Panel Ports and LEDs
This section describes the router rear panel ports and LEDs, which are shown in Figure 1-2
and described in Table 1-2 and Table 1-3.
Figure 1-2 Rear-Panel Ports and LEDs
Kensington-compatible
locking socket
WIC 0 slot
Cisco 1720
WIC0OK
WIC 0
OK LED
Table 1-2 Rear-Panel Connectors
Connector/Slot
Ethernet port
Auxiliary port
Console port
WAN interface card slot
(WICØ)
1-4 Cisco 1700 Router Hardware Installation Guide
Console port
FDX 100 LNK 10/100 ETHERNET
10/100-Mbps
Ethernet port
FDX/100/LNK LEDs Auxiliary port
Label/Color
10/100
ETHERNET
(yellow)
AUX
(black)
CONSOLE
(blue)
No label
WIC 1 slot
CONSOLE
SEE MANUAL BEFORE INSTALLATION
AUX
Description
Connects the router to the local Ethernet network through this
port. This port autosenses the speed (10 Mbps or 100 Mbps) and
duplex mode (full- or half-) of the device to which it is connected
and then operates at the same speed and in the same duplex
mode.
Connects to a modem for remote configuration with Cisco IOS
software.
Connects to a terminal or PC for local configuration using
Cisco IOS software.
Supports one Cisco WAN interface card. For detailed
information, refer to the Cisco WAN Interface Cards Hardware
Installation Guide that comes with every card.
Power switch
DSU
56K
WIC 1 OK
+5, +12, -12 VDC
WIC 1 Power
OK LED socket