Motorola AP-51XX Product Reference Manual page 122

4-30 AP-51xx Access Point Product Reference Guide
2. Configure the SNMP Access Control screen to add the IP addresses of those users receiving
SNMP access.
Access Control List
Add
Edit
Delete
Enter Start IP and End IP addresses (numerical addresses only, no
DNS names supported) to specify a range of user that can access
the access point SNMP interface. An SNMP-capable client can be
set up whereby only the administrator (for example) can use a read/
write community definition.
Use just the Starting IP Address column to specify a single SNMP
user. Use both the Starting IP Address and Ending IP Address
columns to specify a range of addresses for SNMP users.
To add a single IP address to the ACL, enter the same IP address in
the Start IP and End IP fields.
Leave the ACL blank to allow access to the SNMP interface from
the IP addresses of all authorized users.
Click Add to create a new ACL entry.
Click Edit to revise an existing ACL entry.
Click Delete to remove a selected ACL entry for one or more SNMP
users.