Epson BrightLink 450Wi Using

Using the Wall-Mounting Cable Management Kit
Follow these instructions to install the cable management channels on your wall and place the cables in the
channels.
The Wall-Mounting Cable Management Kit includes the parts shown below:
18-inch-long channel
(1 piece)
1 Plan your cable management layout, referring to the illustration below. If you want to connect two 4-foot
channels together (end-to-end), use a seam cover where the channels meet. Use the small connector pieces
to turn corners. Use a hacksaw to cut the channels and channel covers to desired lengths.
Tip
When using a hacksaw, cut the plastic slowly to maintain smooth edges.
Note
The example shown below is for a typical installation, but yours may vary. For example, if the computer is on the right
side of the screen, you should attach the channels to the wall on the right side instead of the left.
Seam
cover
4-foot-long channels
(4 pieces)
Corner connector
(3 pieces)
Drywall screws
(100 pieces)
Seam cover
(10 pieces)
Corner
connector