Panasonic AG-HPD24PJ Operating Instructions Manual page 151

Item Message
CANNOT ACCESS
CARD!
CANNOT ACCESS
TARGET!
CANNOT COPY!
FORMAT STORAGE TO
FAT
CANNOT FORMAT!
CANNOT RECOGNIZE
STORAGE
CANNOT SELECT!
MAX.6 PARTITIONS
CARD IS EMPTY!
CANNOT COPY!
Storage FORMAT P2 CARD!
LACK OF CAPACITY!
STORAGE
DISCONNECTED!
MISMATCH
COMPONENT!
P2 CARD IS
UNFORMATTED!
TOO MANY
PARTITIONS!
UNKNOWN DEVICE
CONNECTED!
VERIFICATION FAILED! Verification after copying failed.
CANNOT CHANGE!
Soft
keyboard
CANNOT SET!
INVALID VALUE!
88
For Long and Trouble-Free Operation: Warning and Error Messages
Description
An error occurred during P2 card access.
An error occurred while trying to access the
connection target.
Clips cannot be copied to a storage device
without partitions.
A storage device cannot be formatted.
The storage device cannot be properly
recognized.
It is not possible to mount a storage device
with more than 6 partitions.
The P2 selected for copying is empty.
Importing is not possible to a P2 card
containing clips.
Not enough space left on the storage device.
The unit has been disconnected from the
storage device.
Copying is not possible since the model
numbers of the two cards differ.
The P2 card is not formatted.
There are too many partitions.
The connected DVD drive or other device is
not supported.
An attempt was made to change PERSON
when no text memo had been entered.
The entered value is invalid.
Measure
Check P2 card.
Check storage device status and connections.
Format using a FAT format or export data from a P2
card to create a partition.
Connect a different storage device.
Reboot the storage device or connect a different
device.
Cancel some of the selected partitions.
Copying is not performed since the card is empty.
Format the P2 card.
Use a new storage device with enough free space or a
formatted storage device.
Reconnect the USB cable to the HOST connector. If the
device still does not operate normally, turn it off and
then back on again.
Use a P2 card with the same model number or import
video in clip units.
Use a formatted P2 card.
Storage device can handle up to 23 partitions. Use a
new storage device or formatted storage device.
Connect a compatible storage device, turn off the unit
and turn it back on again.
Copy the data again.
First enter a text memo.
Enter a valid value.