AEG U 96040-4 i Operating And Installation Instructions page 12

Installation
Push the appliance
into place. The plug
socket necessary for
connection of the
appliance to the elec-
tricity supply should
be positioned, so that
the plug is not placed
in the recess.
3. To adjust the height
proceed as follows:
Loosen or tighten the
two front feet.
The rear feet are adjusted by turning the screw in the front kick plate
to the left or right.
If necessary, pads
rear feet to make sliding the appliance in
and out of the recess easier. To fit the pads,
press them onto the rear feet.
If required, the dimensions of these pads
can be reduced by breaking them where
marked.
4. The joint cover (B) is to be
assembled after having installed
the appliance in the recess.
12
+
-
-
(E) are supplied for the
+
II52
E