Brother LX-300 Service Manual page 28

2. Lift the rear of the Bottom cover in the direction of arrow B while pushing it in the
direction of arrow A to release the six hooks on the rear face.
3. Push the sides of Body cover in the directions indicated by the arrows C to release
the hook at the left and right side.
4. Push on the Y-diversion lever assy and release the two hooks from the front of the
Body cover.
Body cover
C
Front hooks
5. Disconnect the Switch harness assy and the Cover switch assy connectors from the
Main PCB and remove the Body cover.
Cover switch assy
Side hooks
B
A
Y-diversion lever assy
Fig. 3.3-8 Removing the Body Cover 2
Fig. 3.3-9 Removing the Body Cover 3
3-6
Rear hooks
Switch harness assy
Bottom cover B