Cisco SD208T-NA Administration Manual page 217

Configuring IP Information
Management and IP Interfaces
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business 200 Series Smart Switch Administration Guide
Click Administration > Management Interface > IPv6 Neighbors
The IPv6 Neighbors page opens.
You can select a Clear Table option to clear some or all of IPv6 addresses in the
IPv6 Neighbors Table.
• Static Only—Deletes the static IPv6 address entries.
• Dynamic Only—Deletes the dynamic IPv6 address entries.
• All Dynamic & Static—Deletes the static and dynamic address entries IPv6
address entries.
The following fields are displayed for the neighboring interfaces:
• Interface—Neighboring IPv6 interface type.
• IPv6 Address—IPv6 address of a neighbor.
• MAC Address—MAC address mapped to the specified IPv6 address.
• Type—Neighbor discovery cache information entry type (static or dynamic).
• State—Specifies the IPv6 neighbor status. The values are:
- Incomplete
responded.
Reachable
- —Neighbor is known to be reachable.
Stale
- —Previously-known neighbor is unreachable. No action is taken to
verify its reachability until traffic must be sent.
Delay
- —Previously-known neighbor is unreachable. The interface is in
Delay state for a predefined Delay Time. If no reachability confirmation is
received, the state changes to Probe.
Probe
- —Neighbor is no longer known to be reachable, and Unicast
Neighbor Solicitation probes are being sent to verify the reachability.
To add a neighbor to the table, click Add. The Add IPv6 Neighbors page opens.
Enter values for the following fields:
• Interface—The neighboring IPv6 interface to be added.
• IPv6 Address—Enter the IPv6 network address assigned to the interface.
The address must be a valid IPv6 address.
—Address resolution is working. The neighbor has not yet
16
218