Table of Contents
Advertisement
Configuring Filters Using the Web-Browser Interface
Click Add. The Ethertype appears in the Filters Classes field. To remove the Ethertype from the Filters
Step 7
Classes list, select it and click Delete Class. Repeat
Step 8
Select Forward All or Block All from the Default Action menu. The filter's default action must be the
opposite of the action for at least one of the Ethertypes in the filter. For example, if you enter several
Ethertypes and you select Block as the action for all of them, you must choose Forward All as the filter's
default action.
Click Apply. The filter is saved on the access point, but it is not enabled until you apply it on the Apply
Step 9
Filters page.
Click the Apply Filters tab to return to the Apply Filters page.
Step 10
Figure 16-9
Select the filter number from one of the Ethertype drop-down menus. You can apply the filter to either
Step 11
or both the Ethernet and radio ports, and to either or both incoming and outgoing packets.
Click Apply. The filter is enabled on the selected ports.
Step 12
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
16-14
Apply Filters Page
Chapter 16
Step 4
through
Step 7
to add Ethertypes to the filter.
Figure 16-9
shows the Apply Filters page.
Configuring Filters
OL-14209-01
- Quick Links:
- Repeater Access Point
Hide quick links:
Advertisement
Table of Contents
