Troubleshooting; When The Engine Will Not Start - Honda EW140 Owner's Manual

Generator/welder
Hide thumbs Also See for EW140:
Table of Contents

Advertisement

9. .TROUBiESHOOTtNG
A. When the engine will not start:
1. Is the engine switch on?
2. Does the oil alert lamp flash when the starter is pulled?
3. Is there enough fuel?
4. Are all loads disconnected
from the AC receptacles?
5. Is there a spark at the spark plug?
a. Remove the spark plug cap. Clean any dust from around the spark
plug base, then remove the spark plug.
b. Install the spark plug in the plug cap.
c. Turn the engine switch on.
d. Grounding the side electrode to any engine ground, pull the recoil
starter to see if sparks jump across the gap.
m
If any fuel has been spilled,
make sure the area is dry before
tasting
the spark plug. Fuel vapor
or spilled
fuel may ignite.
Perform
this
test in a well-ventilated
area.
e. If there are no sparks, replace the plug.
f. If the new spark plug does not spark, take the generator to an
authorized
Honda dealer.
OIL ALERT LAMP
ENGiNE SWITCH
39

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ew171

Table of Contents