Malfunction Indicator Lamp - Honda Accord Owner's Manual

Main Menu

Malfunction Indicator Lamp

If the indicator comes on
while driving, it means one
of the engine's emissions control
systems may have a problem. Even
though you may feel no difference in
your vehicle's performance, it can
reduce your fuel economy and cause
increased emissions. Continued
operation may cause serious damage.
If you have recently refueled your
vehicle, the indicator coming on
could be due to a loose or missing
fuel fill cap. Tighten the cap until it
clicks at least once. Tightening the
cap will not turn the indicator off
immediately; it takes several days of
normal driving.
362
Table Of Contents
If the indicator comes on repeatedly,
even though it may turn off as you
continue driving, have your vehicle
checked by your dealer as soon as
possible.
If you keep driving with the
malf unction indicator lamp on, you can
damage your vehicle's emissions
controls and the engine. Those repairs
may not be covered by your vehicle's
warranties.
If your vehicle has an automatic
transmission, the malfunction
indicator lamp may also come on
with the ''D'' indicator.
Readiness Codes
Your vehicle has certain ''readiness
codes'' that are part of the on-board
diagnostics for the emissions
systems. In some states, part of the
emissions testing is to make sure
2008 Accord Coupe
these codes are set. If they are not
set, the test cannot be completed.
If the battery in your vehicle has
been disconnected or gone dead,
these codes may be erased. It can
take several days of driving under
various conditions to set the codes
again.
To check if they are set, turn the
ignition switch to the ON (II)
position, without starting the engine.
The malfunction indicator lamp will
come on for 20 seconds. If it then
goes off, the readiness codes are set.
If it blinks five times, the readiness
codes are not set. If possible, do not
take your vehicle for an emissions
test until the readiness codes are set.
Refer to
Emissions Testing
more information (see page
for
389 ).