Advertisement
Installation notes
Electrical connection
Before connecting the appliance, make sure the supply voltage marked on the
Rating Plate corresponds with the mains supply voltage.
WARNING – THIS APPLIANCE MUST BE EARTHED
This appliance is fitted with a moulded-on 13A plug top for connection to a socket
outlet. If it is necessary to remove the plug, the cut off portion must be disposed of
safely to prevent a shock hazard if inserted into a socket outlet.
To fit another plug top, or wire the appliance into a double pole switched fused spur
outlet having 3 mm contact separation, follow the instructions below.
IMPORTANT
The wires in the mains supply lead are coloured in accordance with the following
code:-
The wire coloured Green and Yellow must be connected to the terminal marked 'E'
or the earth symbol ( ⊥ ) or coloured green or yellow.
The wire coloured Blue must be connected to the terminal marked 'N' or coloured
blue or black.
The wire coloured Brown must be connected to the terminal marked 'L' or coloured
brown or red.
NOTE: If connecting to a fused spur, the terminals marked 'SUPPLY' are for the
mains supply wires and the terminals marked 'LOAD' are for the appliance wires.
The electrical outlet should be position in an easily accessible position adjacent to the
appliance.
In the event it is necessary to replace the mains lead, the replacement must conform to
the specification listed in the Technical Data ensuring the correct colour code
connection and all screws are tightened sufficiently.
Cleaning and maintenance
Before cleaning or carrying out any maintenance, disconnect the appliance from
the mains supply.
Do not use caustic or abrasive agents as these can damage the surface finish.
Clean the exterior with a soft cloth dampened with detergent and the removable
accessories with warm detergent but do not place in a washing machine.
Wipe the interior of the appliance with a soft cloth dampened with a solution of warm
water and one or two spoonfuls of vinegar.
Clean the condenser at the rear of the appliance with a soft brush or vacuum cleaner
and wipe over the drain pan fitted to the compressor.
9
Advertisement
