Internal Connectors - Asus P5VD1-X User Manual

2.7.2 Internal connectors

1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for the provided floppy disk drive (FDD) signal cable. Insert
one end of the cable to this connector, then connect the other end to the
signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when
using an FDD cable with a covered Pin 5.
P5VD1-X Floppy disk drive connector
2. Primary/Secondary IDE connector (40-1 pin PRI_IDE,
SEC_IDE)
This connector supports the provided UltraATA133 IDE hard disk ribbon cable.
Connect the cableʼs blue connector to the primary (recommended) or secondary
IDE connector, the black connector for the UltraATA133 master device.
1. Follow the hard disk drive documentation when setting the device in master
2. Pin 20 on each IDE connector is removed to match the covered hole on the
3. The hole near the blue connector on the UltraATA cable is intentional.
P5VD1-X IDE connectors
2-22
P5VD1-X
®
or slave mode.
UltraATA cable connector. This prevents incorrect orientation when you
connect the cables.
P5VD1-X
®
FLOPPY
PIN 1
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
Chapter 2: Hardware Information