1.1
Installing and charging the
cordless handset battery pack
1. Slide off the battery compartment cover to remove it.
2. Place the supplied rechargeable battery pack in the
battery compartment, with the battery connector
plugged in, as shown.
3. Slide the battery compartment cover back on.
Getting Started
4. Put the handset on the charger to charge for at
least 24 hours. Once charged, the
that the handset is fully charged.
5. Use only the rechargeable battery pack provided.
1.2
Assembling the rubber band of
cordless handset (Not applicable
for L70xCM models)
If you have purchased additional rubber band(s) of the
cordless handset separately, refer to the following steps
for replacement. To remove the originally installed
rubber band, dig out the rubber band from handset
bottom gap and then take it off from handset around.
1. To assemble the rubber band, align the protuberant
pins of the rubber band with the holes around of the
handset sides and click the rubber band into place.
Respect the direction, side with gap should be
attached to the handset bottom, as shown.
will indicate
7