Honeywell XL4600SM Owner's Manual page 9

T(VRNING THE SYSTEM ON
TURN THE SYSTEM ON WITH ALL SENSORS IN INSTANT RESPONSE MODE
In INSTANT mode, all alarm sensors will repoti an alarm immediately if
activated, including the doors that normally have adelayto allow youto turn the
system oti. Chackto make eurethe system is ready when ready press
ED
Followed byyour usercode mmmrl
If successful, the On/Off light and the Inetant light will be on, or the display
shows.
BYPASS
Bypass excludes a zone of protection from the security system until it is
unbypsssed (either by using the unbypaes procedure or when you turn the
eystem off). Bypassing can only be done while the system is turned off.
Press the Bypass Button followed by your user code and then the zone number
(l-7) to be bypassed.
m
Followed byyour usercode+ rlmmr{ + ZONE#
+ If the "Quick Bypass" feature has been enabled by the installer, the user code is
not required when bypassing zones.
NOTE: Bypassed zones are not protected when the system is turned on. After
the bypass command has been accepted, the keypad will sound one long beep,
and the zonetight of the zone(s) bypassed will slowly blink, or the display shows:
IMPORTANT: Temporary users ~.e, baby sifters, housekeepers, etc.) should not
be shown the Bypass procedure.
UNBYPASS
Unbypass returns a bypassed zone to normal operation. To unbypass a zone(s),
repeat the bypass function.
m
Followed byyourusercode
rlnrlrl+ ZONES
After unbypassing the zone display will show the state of the zones.
Pages