Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
DRIVE MOTOR
Connector
Refer to page 4-10 for the procedure for ac-
cessing the drive motor.
1.
Unplug dryer or disconnect power.
2.
Turn off gas supply to dryer.
3.
Disconnect the wire connector from the mo-
tor terminals.
4.
Set the ohmmeter to the R x 1 scale.
5.
Measure the drive motor main and start
windings, as shown in the chart.
WARNING
Electrical Shock Hazard
Main Winding:
Blue Wire (In Back and Bare)
Copper Wire (Pin 5)
Blue Wire (In Back and Bare)
Copper Wire (Pin 3)
WINDING
MAIN
START
5-6
Start Winding:
RESISTANCE
CONTACT POINTS
Ω
OF MEASUREMENT
Blue wire in back at
pin 4 and bare copper
1.4 – 2.6
wire on pin 5 of black
drive motor switch
Blue wire in back at
pin 4 and bare copper
1.4 – 2.8
wire on pin 3 of black
drive motor switch