Technical Data; Installation - AEG EN AGN2451 User Manual

Table of Contents

Advertisement

Problem
The lamp does not work.
Door interferes with venti-
lation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.
Replacing the lamp
The appliance is equipped with a longlife LED light.
Only service is allowed to replace the lighting device. Contact your Service Center
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installation".
3.
If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Possible cause
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
The door has been open to long.
The appliance is not levelled.
The appliance is not levelled.
Height
Width
Depth
Connect another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
Refer to "Replacing the lamp".
Close the door.
Refer to "Levelling".
Refer to "Levelling".
AGN2451
1650 mm
660 mm
680 mm
25 h
230 V
50 Hz
15
Technical data
Solution
AGN2901
1850 mm
660 mm
680 mm
25 h
230 V
50 Hz

Advertisement

Table of Contents
loading

This manual is also suitable for:

Agn2901

Table of Contents