HP StorageWorks 2/32 - SAN Switch Release Note page 40

Fabric OS Commands
errSaveLvlSet Command
Short Description: Set error save level of a switch. This command is new for
Fabric OS V4.0.2b or higher.
Syntax
Availability
Description
Use this command to control types of messages that are saved in the persistent
error log. Message types are based on the message severity levels. By default, all
messages of type Panic and Critical are saved in the persistent log. If you want to
save messages of log levels less severe than Critical, use this command to specify
a new message save level.
This new message save level is not persistent across a reboot. It is in effect only
for that run time cycle.
When this command is executed from the Standby CP, the switch instance number
operand is required. The switch instance number is supplied by specifying the
<-s swinst> operand.
This operand is not required when logged into the Active CP.
Operands
This command has the following operands:
s swinst - This is an optional parameter. It shows switch instance number.
This parameter is required on the Standby CP. This parameter should not be used
on the Active CP. You must follow -s with the switch instance number where the
command is to be executed. Valid values for switch instance are 0 (for the switch
instance associated with slots 1 though 4) or 1 (for the switch instance associated
with slots 6 though 10).
lvl - Message severity level. Save those error log messages whose message
severity level is less than (more severe) or equal to this level. The valid values are:
40
errSaveLvlSet [-s swinst] lvl
admin
Critical 1
Error 2
Warning 3
Info 4
SAN switch 2/32 Version 4.0.2b Release Notes