HP P6000 Replacement Instructions page 3

Hp storageworks disk enclosure vrm replacement instructions (504218-001, september 2009)

Hide thumbs Also See for P6000:

Enlarged version

Disconnect the VRM cables from the backplane.

10.

Loosen the thumbscrew (T-15 may be needed) securing the VRM

(1) and then slide the VRM towards the center of the chassis and

lift up as indicated to release the VRM from the four guideposts (2).

11.

Lift the VRM and its cables up and out of the chassis.

Installing the VRM

Thread the VRM cables through the opening in the chassis and then

align the replacement VRM on the guide posts on the bottom of the

chassis and top of the power supply cage.

Slide the VRM into position then push down to seat (1), tighten the

thumbscrew (T-15 may be needed) to secure the VRM (2).

Page 3

Table of Contents