Table of Contents
Advertisement
90539499 01 EM100B.qxd
7/7/08
4 .
Tu rn the Sensor A rm so that the two Sensor
LEDs are visible (4). T h ey need to be able to see the
Optical Po rt on the mete r.
5 .
Push the smaller end of the Sensor A rm upwa rds
t h rough the latch opening and press the Sensor A rm
fi rm ly into the cavity (5).
6 .
Slide the Sensor A rm as far down as it will go into the
b o ttom cavity of the body. If necessary, use a dull
p o i n ted object, such as a ballpoint pen, to push it all the
way down (6). The two Sensor LEDs must be visibl e.
7 .
Tu ck the wire into the side cavity (7).
8 .
Close the latch (8).
9 .
Re t h read the clamping strap into the sensor
housing and re a ttach the ends. Tu rn the screw
as you feed in the end to re a ttach it.
14
10:05 AM
Page 14
Sensor LED's
0 3 I N S TALLING YOUR METER SENSOR
TYPE 3—ELECTRONIC WITH OPTICAL PORT ON TO P
C . Install Your Meter Sensor
The objective of this step is to align the Sensor
LEDs dire c t ly over the optical port on the mete r.
1.
S tand dire c t ly in front of your electric mete r, at
a height where you can see the optical port .
The optical port itself looks like a small
p ro t ruding pipe in the center of the top port i o n
of the electric mete r. Ca re f u l ly wipe the mete r
dome clean with the damp cloth.
2 .
Peel the adhesive backing off of the te m p l a te.
Hold the te m p l a te with the pro t ruding tab fa c i n g
you and the arrow pointing away from yo u .
3 .
S t i ck the te m p l a te onto the meter with the
a r row pointing at, but not cove ring the optical
p o rt . You can peel the te m p l a te off the glass
and realign it if necessary.
4 .
Align the edges of the sensor with the white
side lines on the te m p l a te. Slide the Mete r
Sensor over the glass dome as far as it will go.
5 .
Ti g h ten the clamp until the Meter Sensor
is snu g, but can move just enough to allow
for adjustments.
6 .
Open the Sensor A rm Latch Cover and
look down the opening. Yo u'll see a ve rt i c a l
plastic tab painted white on the inside of the
Sensor body.
7 .
Look through the opening and confi rm that the
tip of the white plastic tab on the Sensor is
lined up with the arrow line on the te m p l a te.
Adjust the position of the sensor if necessary.
8 .
Press the RESET bu tto n . Within 10 seconds,
the STATUS indicator will light solid red while
the Meter Sensor looks for a signal from the
m e te r. When the Sensor is corre c t ly aligned,
the Status indicator will bl i n k .
Status
Reset
Indicator
Button
15
Hide quick links:
Advertisement
Table of Contents
