Presetting the Stations Manually
You do not need to preset the stations
manually if you have already set
them automatically.
To enable the VCR to decode a
scrambled TV station, the decoder
must be switched on.
1
Press the MENU button on the remote control.
Result: The programming menu is displayed.
2
Press the corresponding
select the INSTALLATION option.
3
Press the OK button to select this option.
Result: The INSTALLATION menu is displayed.
4
Press the corresponding
the MANUAL SET UP option is selected.
5
Press the ❿ button to select MANUAL SET UP
option.
Result: The TV STATION TABLE menu is
displayed.
6
Press the
or
buttons to select a programme
❷
number as required.
7
Press the ❿ button to preset the station.
Result: The MANUAL TUNING menu is displayed.
8
Press the
or
buttons, until the SYSTEM is
❷
selected.
9
Select the required system by pressing the ➛ or ❿
buttons.
10
Press the
or
buttons until the CH selected.
❷
11
Press the ➛ or ❿ buttons to start scanning.
Result: The frequency band is scanned and the
first station found is displayed.
If you know the number of the channel you want,
press the numeric buttons on the remote control
for example, for channel E21, first press "0" and
then press "2", "1" (see page 30).
12
Press the
button, until the DECODER is
❷
selected.
13
Press the ❿ button to activate or deactivate use of
the decoder for the TV station, if necessary.
or ➛, ❿ buttons to
,
❷
or
buttons, until
❷
ENG-12
14
Press the
or
buttons until the NAME is selected.
❷
15
To change the programme's name, press the ❿
button.
Result: The first letter of the name flashes.
16
To...
Then...
Select a character Press the
in the name
the required character is displayed
(letters, numbers or "-" character).
Move to the next Press the ➛ or ❿buttons
or previous
respectively.
character
17
If you...
Then...
Wish to store the
station displayed
Do not wish to
store the station
displayed
18
Repeat this procedure from Step 6 onwards, until
all the required stations have been stored.
19
On completion, press the MENU button three times
to exit the menu.
or
button until
❷
Press the corresponding
or
buttons, until the MFT
❷
is selected.
Press the ➛ or ❿ buttons to
adjust the picture, if necessary.
Press OK to store the station .
Press the corresponding
or
buttons, until the CH
❷
is selected.
Press the ➛ or ❿ buttons to
go on scanning the frequency
band and display the next
station
Go back to the beginning of
Step 14