Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 47

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c . c o m .
CSCsu84919
•
Symptom: When hosts are continuously logging into virtual targets (VTs), the iSAPI process might
leak memory which might cause the SSM to fail.
Workaround: This issue is resolved.
CSCsu98190
•
Symptom: During an upgrade from Cisco MDS SAN-OS Release 3.3(1c) to Cisco NX-OS 4.1(1b)
and later, applications might experience a very small amount of packet drops in the fabric. Most of
the applications should be able to recover from such a small packet loss. The problem is seen only
with an upgrade from SAN-OS Release 3.3(1c) and is not seen with an upgrade from either SAN-OS
Release 3.3(1a) or SAN-OS Release 3.3(1b).
Workaround: This issue is resolved.
CSCsv27564
•
Symptom: In rare cases, following a downgrade from an NX-OS 4.x image to a SAN-OS 3.x image,
the available space on the bootflash might be displayed as less than the actual space that is available.
Workaround: This issue is resolved.
CSCsx63346
•
Symptom: If encryption is in use when you open a fabric, you cannot launch Device Manager from
Cisco Fabric Manager.
Workaround: This issue is resolved.
CSCso63465
•
Symptom: FCP-CMD (for example, Inquiry) frames targeted to LUN 0x45F0 or LUN 0x50F0 are
dropped by an MDS switch when traffic flows (egresses) through Generation 2 modules. LUN
0x45F0 corresponds to HPUX Volume Set Address <VBUS ID: 0xB, Target ID: 0xE, LUN: 0x0>.
Workaround: This issue is resolved.
CSCsr69166
•
Symptom: Solaris Windows Manager does not resize windows correctly which effects some Device
Manager screens.
Workaround: This issue is resolved.
CSCsu23984
•
Symptom: Starting with MDS NX-OS 4.1(1), a password security feature was introduced that
allowed a user to enable a secure password standard. However, this feature was not being enforced
for SNMP users.
Workaround: This issue has been resolved.
CSCsu30034
•
Symptom: During and In Service Software Upgrade (ISSU), throughput statistics will not be
available from the switch undergoing an upgrade. This information will be not able available from
the CLI or Device Manager via SNMP.
Workaround: This issue is resolved.
CSCsu37199
•
Symptom: Errors on the management port (mgmt0 or eth1) may be seen in the output of the show
logging log command.
OL-17675-05
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(3a)
Caveats
47