Cisco AJ732A - MDS 9134 Fabric Switch Quick Reference Manual page 35

Cisco mds 9000 family mib quick reference (ol-18087-01, february 2009)

Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

CISCO-FLEXATTACH-MIB

This MIB enables the automatic generation of virtual WWNs on all of the Fport interfaces whose

fcIfOperMode is 'fPort'.

The Nxports register with the Fxports with a port WWN as indicated by object fcNameServerPortName

in the CISCO-NS-MIB. Generally, the Nxports are zoned with other devices which they need to

communicate using this port WWN. However, if the device containing Nx port has to be replaced, zoning

has to be reconfigured using the port WWN of the new device to eliminate the need for a zoning change,

a special WWN is assigned to the corresponding Fport and the original port WWN is replaced with this

special WWN for any device that is logging through the Fport. In addition, the zoning is configured using

the special WWN.

CISCO-FSPF-MIB

This MIB configures and monitors the Fabric Shortest Path First (FSPF) parameters on all VSANs

configured on the local switch. FSPF is the protocol currently standardized by the T11 committee for

routing in Fibre Channel networks. Refer to http://www.t11.org.

CISCO-HC-ALARM-MIB

This MIB defines RMON-MIB(RFC 2819) extensions for high-capacity alarms. This MIB is based on

the Internet Draft (draft-ietf-rmonmib-hc-alarm-mib-02.txt). In terms of object syntax and semantics,

the content of this Cisco MIB is the same as the corresponding Internet Draft revision. This Cisco MIB

was created because of the "subject to change" nature of Internet Drafts. This Cisco MIB eventually

maybe replaced by a stable RFC.

This MIB configures RMON alarms that require high-capacity counters (64-bit counters).

CISCO-IETF-IP-FORWARD-MIB

This MIB was extracted from the draft-ietf-ipngwg-rfc2096-update-00.txt. In terms of object syntax and

semantics, the content of this Cisco MIB is the same as the corresponding I-D revision. This Cisco MIB

is created due to the "subject to change" nature of the I-Ds. This Cisco MIB may later be deprecated,

and the stable RFC, which may replace the I-D, may be implemented in its place.

Americas Headquarters:

Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA