Hood Sensor - HP 8100 - Elite Convertible Minitower PC Maintenance And Service Manual

Hood Sensor

The hood sensor is attached in a slot in the rear of the chassis.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Unplug the sensor cable from the white system board connected labeled HSENSE.
4. Slide the hood sensor straight out of the notch in the chassis.
NOTE:
Figure 7-55
To install the hood sensor, reverse the removal procedure.
(Computer Access Panel on page
A flat blade screwdriver can be used to push the hood sensor out of the slot.
Removing the hood sensor from the chassis
(Preparation for Disassembly on page
99).
90).
Hood Sensor 133