Cisco 3020 - Catalyst Blade Switch Release Note page 27

Private VLANs and Unicast, Broadcast, and Multicast Traffic
In regular VLANs, devices in the same VLAN can communicate with each other at the Layer 2 level, but
devices connected to interfaces in different VLANs must communicate at the Layer 3 level. In private
VLANs, the promiscuous ports are members of the primary VLAN, while the host ports belong to
secondary VLANs. Because the secondary VLAN is associated to the primary VLAN, members of the
these VLANs can communicate with each other at the Layer 2 level.
In a regular VLAN, broadcasts are forwarded to all ports in that VLAN. Private VLAN broadcast
forwarding depends on the port sending the broadcast:
•
•
•
Multicast traffic is routed or bridged across private-VLAN boundaries and within a single community
VLAN. Multicast traffic is not forwarded between ports in the same isolated VLAN or between ports in
different secondary VLANs.
Private VLANs and SVIs
In a Layer 3 switch, a switch virtual interface (SVI) represents the Layer 3 interface of a VLAN. Layer 3
devices communicate with a private VLAN only through the primary VLAN and not through secondary
VLANs. Configure Layer 3 VLAN interfaces (SVIs) only for primary VLANs. You cannot configure
Layer 3 VLAN interfaces for secondary VLANs. SVIs for secondary VLANs are inactive while the
VLAN is configured as a secondary VLAN.
•
•
When the primary VLAN is associated with and mapped to the secondary VLAN, any configuration on
the primary VLAN is propagated to the secondary VLAN SVIs. For example, if you assign an IP subnet
to the primary VLAN SVI, this subnet is the IP subnet address of the entire private VLAN.
Configuring Private VLANs
These sections contain this configuration information:
•
•
•
•
•
•
•
OL-14130-02
An isolated port sends a broadcast only to the promiscuous ports or trunk ports.
A community port sends a broadcast to all promiscuous ports, trunk ports, and ports in the same
community VLAN.
A promiscuous port sends a broadcast to all ports in the private VLAN (other promiscuous ports,
trunk ports, isolated ports, and community ports).
If you try to configure a VLAN with an active SVI as a secondary VLAN, the configuration is not
allowed until you disable the SVI.
If you try to create an SVI on a VLAN that is configured as a secondary VLAN and the secondary
VLAN is already mapped at Layer 3, the SVI is not created, and an error is returned. If the SVI is
not mapped at Layer 3, the SVI is created, but it is automatically shut down.
Tasks for Configuring Private VLANs, page 28
Default Private-VLAN Configuration, page 28
Private-VLAN Configuration Guidelines, page 28
Configuring and Associating VLANs in a Private VLAN, page 31
Configuring a Layer 2 Interface as a Private-VLAN Host Port, page 33
Configuring a Layer 2 Interface as a Private-VLAN Promiscuous Port, page 34
Mapping Secondary VLANs to a Primary VLAN Layer 3 VLAN Interface, page 35
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(40)SE1 and Later
Documentation Updates
27