3.
Install the IO Accelerator card as shown below.
The following illustration demonstrates installing the IO Accelerator on a full-height server blade.
The following illustration demonstrates installing the IO Accelerator on a half-height server blade.
4.
Reinstall the server blade access panel and then reinstall the server blade in its operating position
in the server blade enclosure.
Verifying Hardware Installation
After powering up the server in the BladeSystem chassis, you can verify that the mezzanine card has
been installed correctly using the HP BladeSystem Onboard Administrator.
Refer to the Information tab of the Device Bay containing the server blade. The "Mezzanine Card
Information" section will show if the cards have been detected properly. For example
12
Hardware installation