Hardware Installation; Installing The Hp Storageworks Io Accelerator - HP AJ878A - StorageWorks 320 GB Hard Drive User Manual

2 Hardware installation

Included:

Installing the HP StorageWorks IO Accelerator

Verifying Hardware Installation
Installing the HP StorageWorks IO Accelerator
WARNING!
To reduce the risk of personal injury from hot surfaces, allow drives and internal system components
to cool before touching them.
WARNING!
Reduce the risk of electric shock by removing all AC power from the system before installing or
replacing any non-hot-plug hardware option. Disconnect all power cords to completely remove power
from the server.
CAUTION:
Electrostatic discharge (ESD) can damage electronic components. Be sure that you are properly
grounded (earthed) before beginning any installation procedure.
1. Remove the desired server blade from the enclosure, and then remove the server blade access
panel.
a. Identify the proper server blade in the enclosure.
b. Back up all server blade data.
c. Stop all activity on the server and then power down the server blade.
d. Remove the server blade from the enclosure.
e. Lift the access panel latch, slide the access panel to the rear, and then remove the access
panel and set aside.
2. Remove any protective covering from the IO Accelerator.
IO Accelerator for BladeSystem c-Class user guide 11