Cisco WRP400-G1 - Wireless Router Administration Manual page 100

Advanced Voice Fields
Line page
Cisco Small Business WRP400 Administration Guide
Referor Bye Delay
Refer Target Bye
Delay
Referee Bye Delay
Refer-To Target
Contact
Sticky 183
Auth INVITE
Voice tab > Line page >
Call Feature Settings section
Blind Attn-Xfer
Enable
Controls when the WRP400 sends BYE to terminate stale
call legs upon completion of call transfers. Multiple delay
settings (Referor, Refer Target, Referee, and Refer-To
Target) are configured on this screen. For the Referor Bye
Delay, enter the appropriate period of time in seconds.
The default is 4.
For the Refer Target Bye Delay, enter the appropriate
period of time in seconds.
The default is 0.
For the Referee Bye Delay, enter the appropriate period of
time in seconds.
The default is 0.
To contact the refer-to target, select yes. Otherwise, select
no.
The default is no.
If this feature is enabled, the IP telephony ignores further
180 SIP responses after receiving the first 183 SIP
response for an outbound INVITE. To enable this feature,
select yes. Otherwise, select no.
The default is no.
When enabled, authorization is required for initial incoming
INVITE requests from the SIP proxy.
Enables the WRP400 to perform an attended transfer
operation by ending the current call leg and performing a
blind transfer of the other call leg. If this feature is disabled,
the WRP400 performs an attended transfer operation by
referring the other call leg to the current call leg while
maintaining both call legs. To use this feature, select yes.
Otherwise, select no.
The default is no.
A
98