Linksys WMP300N User Manual page 8

Chapter 3
Then click Connect and proceed to step 3.
WPA-Personal (Wi-Fi Protected Access)
If your network has the wireless security WPA-Personal
enabled, this screen will appear.
WPA-Personal Needed for Connection
Encryption
Select the type of algorithm you want to use,
TKIP or AES, from the Encryption drop-down menu.
Pre-shared Key Enter a Pre-shared key of 8-63 characters
in the Pre-shared Key field.
Then click Connect and proceed to step 3.
WPA2-Personal (Wi-Fi Protected Access 2)
If your network has the wireless security WPA2-Personal
enabled, this screen will appear.
WPA2-Personal Needed for Connection
Pre-shared Key
Enter a Pre-shared Key of 8-63 characters
in the Pre-shared Key field.
Then click Connect and proceed to step 3.
After the software has been successfully installed, the
Congratulations screen will appear. Click Finish to exit. For
more information about the Wireless Network Monitor,
Wireless-N PCI Adapter
refer to "Chapter 5: Using the Wireless Network Monitor. "
Congratulations! The installation of the Wireless-N
PCI Adapter is complete.
Advanced Setup
If your network is not listed with the available networks,
you can use Advanced Setup.
1. Click Advanced Setup on the Available Wireless
Network screen to set up the Adapter manually.
Available Wireless Networks
2. The Network Settings screen from the Wireless Network
Monitor will appear. If your network has a router or
other DHCP server, click the Obtain network settings
automatically (DHCP) radio button.
Network Settings
If your network does not have a DHCP server or router,
click the Specify network settings radio button. Enter
an IP Address, Subnet Mask, Default Gateway, and DNS
addresses appropriate for your network. You must
specify the IP Address and Subnet Mask on this screen.
If you are unsure about the Default Gateway and DNS
addresses, leave these fields empty.
Configuration
5