Modifying The Terminal Preference - Xerox 3100MFPX - Phaser B/W Laser Instructions Manual

S
ETTINGS
On the multifunction terminal:
Put the terminal in registration mode:
891 - ADVANCED FCT / DECT /
REGISTER
On the machine, press
the keypad and confirm with OK.
The machine starts searching for the hand-
set.
During the registration process (up to
one minute), the LCD screen displays
HANDSET REGISTRATION
message disappears once registration is
complete.
If the registration process fails (for
example, the handset left the
registration mode too soon), the
machine emits a 3-beep signal. In
this case, repeat the procedure from
step 1.
The new handset and the base are mutually
searching for each other. The registration
may take several seconds.
Once the handset is registered, the handset
automatically exits the registration mode and
lets you know the registration is done.
You can also set your base to the
registration mode using a handset
already registered by selecting the
Registration function in the menu
SETTINGS/ADVENCED SET./SET
BASE.
, enter 891 using
. The
31
Modifying the terminal
preference
This function enables you to specify which
base will be used by your handset to make
calls (if your handset is registered to several
bases).
On the navigator key
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET.. Press Valid.
Select SET HANDSET. Press Valid.
Select BASE PRIORITY using
Press Valid. .
An information screen presents the current
base preference for your handset.
• To keep the preference, press
Valid. .
• To modify the preference, press
Edit .
A list provides the bases among which you
can choose the preferred base to which you
want your handset to be registered. With the
automatic mode you are not required to
specify the preference.
Select the base preference using
Press Valid. .
To exit the menu, press the red key
, press or
.
.
or .
or .
.