Registering A New Handset To A Terminal - Xerox 3100MFPX - Phaser B/W Laser Instructions Manual

S
ETTINGS
Select CHANGE CODE using
Valid. .
Enter the old base code using the keypad
(default is 0000). Press Valid.
Enter the new base code using the keypad.
Press Valid. .
Confirm by entering the new base code
again. Press Valid.
To exit the menu, press the red key
Carefully note down the base code
number. You will need this code to
change certain settings.
or . Press
.
.
.
30
H
ANDSET SETTINGS
Registering a new handset to a
terminal
To register a new handset to a base you
must:
• put the handset in registration mode,
• put the base in registration mode.
Once this is done, the registration (mutual
recognition of the base and the new handset)
will be done automatically (registration can
take a few seconds).
Take the handset to be registered:
On the navigator key
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using
Press Valid. .
Select SET HANDSET using
Valid. .
Select REGISTRATION. Press Valid.
Press Yes to put the handset in
registration mode.
The handset enters the registration mode.
, press or
or .
or . Press
.