Viewing A List Of Attached Devices; Upgrading The Router Software - NETGEAR WGT624v1 - 108 Mbps Wireless Firewall Router Reference Manual

Viewing a List of Attached Devices

The Attached Devices menu contains a table of all IP devices that the router has discovered on the
local network. From the Main Menu of the browser interface, under the Maintenance heading,
select Attached Devices to view the table, shown below.
Figure 6-4: Attached Devices menu
For each device, the table shows the IP address, NetBIOS Host Name (if available), and Ethernet
MAC address. Note that if the router is rebooted, the table data is lost until the router rediscovers
the devices. To force the router to look for attached devices, click the Refresh button.

Upgrading the Router Software

The routing software of the WGT624 wireless router is stored in FLASH memory, and can be
upgraded as new software is released by NETGEAR.
Note: The web browser used to upload new firmware into the WGT624 wireless router must
support HTTP uploads. Use Microsoft Internet Explorer or Netscape Navigator 4.0 or above. Do
not interrupt the upgrade process once it has started.
Note: Be sure to check the NETGEAR web site for documentation updates which are
available at http://www.netgear.com/docs.
Maintenance
Reference Manual for the 108 Mbps Wireless Firewall Router WGT624
M-10153-01
6-5