Cisco AIR-BR350-A-K9 - Aironet 350 Wireless Bridge Hardware Installation Manual page 28

Connecting the Ethernet Cables
Connect the other end of the Ethernet cable to the device that will supply power.
Step 3
If you are using a power injector, follow these additional steps:
Plug the straight-through, Category 5 Ethernet cable from the bridge into the port on the power
a.
injector labeled To AP/Bridge.
Note
b. Plug a straight-through, Category 5 Ethernet cable into the port on the power injector labeled To
Network.
c. Plug the other end of the Ethernet cable into your 10/100 Ethernet switch, hub, or network.
d. Plug the female end of the power cord into the universal power supply.
e. Plug the male end of the power cord into a wall outlet or power strip.
Secure the power injector in place with the tie-wraps. Insert the tie-wraps through the slots on the
f.
bottom of the power injector and fasten the tie-wraps around a pole or a bundle of wires, or use the
wall anchor and screw to secure the power injector to a wall.
At start-up, all three LEDs on the top of the bridge slowly blink amber, red, and green in sequence; the
power-up sequence takes a few minutes to complete. During normal operation, the LEDs blink green.
Refer to
Follow the steps in
Step 4
Cisco Aironet 350 Series Bridge Hardware Installation Guide
2-8
Attach the provided warning labels to the powered Ethernet cable or the wall jack to warn other
users that the Ethernet connection carries inline power.
Chapter 4, "Troubleshooting,"
Chapter 3, "Basic Configuration,"
for LED descriptions.
to assign basic settings to the bridge.
Chapter 2 Installation
OL-1412-01