NETGEAR PTV1000 - Push2TV - TV Adapter Installation Manual

Installation Guide
Push 2 TV Adapter (PTV1000)/Intel® Wireless Display
tag

Package Contents

Push 2 TV
Power cord
HDMI cable
Push 2 TV Front and Back Views
Power On/Off HDMI Composite
Installation
To install and set up the Push 2 TV adapter:
1. Connect the Push 2 TV adapter to your TV and plug in the power cord.
The Push 2 TV adapter LED is red when it powers up. Then the LED turns yellow
to indicate it is ready, but is not yet connected to your computer.
2. Turn on your TV and select the correct TV input source for your TV.
• If you are not sure which input source should be used, check the
documentation that came with your TV set.
• The Ready for Connection screen displays on your TV within 30 seconds.
LED
If you do not see this screen, make sure the TV input is set to the port where the
Push 2 TV adapter is connected and all cable connections are firmly secured.
Reset
3. On your laptop, launch the Intel Wireless Display software. There are two ways
to do this:
• If your laptop has a button or key, press it.
• From Windows select Start. Type Intel Wireless Display in the search
field. Select and run the Intel Wireless Display software.
4. Use the Intel Wireless Display software to scan and find the Push 2 TV adapter.
The screen on the right shows that the Intel
Wireless Display software has found the
wireless adapter.
5. Double-click the Push 2 TV adapter to connect
to it. The LED on the Push 2 TV adapter starts
flashing green.
6. If you are connecting the laptop to the Push 2
TV adapter for the first time, the Push 2 TV
adapter displays a 4-digit security code on the
TV. Enter this 4-digit security code into the Intel
Wireless Display software.
7. Within a few seconds the TV screen will display your laptop screen. The LED on
the Push 2 TV adapter turns solid green.
You are now ready to use Push 2 TV/Intel Wireless Display.