Projector Alignment - NEC LT30 - XGA DLP Projector Installation And Assembly Manual

Slide connection block with projector into projector mount
assembly (A) as shown. Tighten captive screw to secure
projector to projector mount assembly (A).
FRONT OF MOUNT
CAPTIVE SCREW

Projector Alignment

Projector Alignment
Projector Alignment Projector Alignment Projector Alignment
To adjust yaw (swivel) for wood stud, concrete ceiling, and threaded rod mounting applications:
Loosen wood screws (F) (refer to step two), or locknuts for threaded rods (refer to step four), until projector
mount can be rotated. Rotate mount to desired position and retighten screws or locknuts.
To adjust yaw (swivel) for extension column applications: Loosen screw on projector mount assembly (A)
indicated below until projector mount can be rotated. Rotate mount to desired position and retighten screw.
To adjust pitch (forward and backward tilt): Loosen two screws on projector mount assembly (A) indicated
below. Tilt mount to desired position and retighten screws.
To adjust roll (side to side tilt): Loosen two screws on projector mount assembly (A) indicated below. Tilt
mount to desired position and retighten screws.
SCREWS FOR PITCH
ADJUSTMENT
SCREW FOR SWIVEL STOP
Visit the Peerless Web Site at www.peerlessmounts.com
CONNECTION BLOCK
A
A
IMPORTANT: For security installations, insert
one #10-32 x 1/4" socket pin screw (D) through
projector mount assembly (A) and into connection
block as shown.
D
7 of 7
For customer service call 1-800-729-0307 or 708-865-8870.
A
CONNECTION BLOCK
SCREWS FOR ROLL
ADJUSTMENT
BACK OF MOUNT
ISSUED: 10-13-05 SHEET #: 055-9445-2 03-31-06