In this chapter, the following examples are provided:
•
"Add a New Community"
•
"Enable SNMP Trap" on page 20-2
•
"Configure SNMP V3" on page 20-3
•
"sFlow" on page 20-5
•
"Configure Time-Based Sampling of Counters with sFlow" on page 20-9
Add a New Community
The example is shown as CLI commands and as a Web interface procedure.
CLI: Adding a New Community
(Netgear switch) #config
(Netgear switch) (Config)#snmp-server community rw public@4
Web Interface: Adding a New Community
To use the Web interface to add a new community, proceed as follows:
1.
From the main menu, select System > SNMP>SNMP V1/V2>Community Configuration. A screen
similar to the following displays.
Figure 20-1
2.
In the Community Name field, enter public@4.
v1.0, October 2009
Chapter 20 SNMP
20-1