Set Storage Array Redundancy Mode; Set Storage Array Security Key - Dell PowerVault MD3260 Cli Manual

Parameters
Parameter
daysToNextLearnCycle
day
time
NOTE: You can set the learn cycle to occur only once during a seven-day period. The time parameter selects a
specific time that you want to run the learn cycle. If a value is not entered, the command uses a default value of
00:00 (midnight). If the day and time specified are in the past, the next learn cycle takes place on the next possible
day specified.

Set Storage Array Redundancy Mode

This command sets the redundancy mode of the storage array to either simplex or duplex.
Syntax
set storageArray redundancyMode=(simplex | duplex)
Parameter
Parameter
redundancyMode

Set Storage Array Security Key

Use this command to set the security key that is used throughout the storage array to implement the Physical Disk
Security premium feature. When any security-capable physical disk in the storage array is assigned to a secured disk
group, that physical disk is security-enabled using the security key. Before you can set the security key, you must use
the create storageArray securityKey command to create the security key.
Syntax
set storageArray securityKey
Parameters
None.
Additional Information
Security-capable physical disks have hardware to accelerate cryptographic processing and each has a unique physical
disk key. A security-capable physical disk behaves like any other physical disk until it is added to a secured disk group.
When a security-capable physical disk is added to a secured disk group, it becomes security-enabled.
186
Description
Valid values are 0 through 7, where, 0 is immediately and
7 is in seven days. The daysToNextLearnCycle
parameter takes place up to seven days after the next
scheduled learn cycle.
Valid values for the day parameter include the days of the
week. Setting the day causes the next learn cycle to be
scheduled on the specified day, after the currently
scheduled learn cycle.
The time in 24-hour format; for example 8:00 a.m. is
entered as 08:00. Nine o'clock p.m. is entered as 21:00, and
9:30 p.m. is entered as 21:30.
Description
Use simplex mode when you have a single RAID controller
module. Use duplex mode when you have two RAID
controller modules