Reduce Disk Pool Capacity; Remove Remote Replication - Dell PowerVault MD3260 Cli Manual

• During snapshot re-creation, all affected virtual disks (snapshots, base, and repository) are appropriately
quiesced and I/O operations are resumed to all affected virtual disks after all snapshots have been successfully
re-created.
NOTE: If the warningThresholdPercent parameter or the repositoryFullPolicy parameter is not
specified, the previously set values are used. If you use the optional parameters, the re-create snapshot processes
each snapshot virtual disk separately. If the same userLabel (name) is specified for more than one virtual disk, the
command fails. If no optional parameters are specified, the re-create Snapshot processes the specified snapshot
virtual disks as a batch, provided a validation check of all of the virtual disks runs successfully. If successful, the
snapshots start the re-creation process and all of the affected virtual disks (snapshot, source, and repository) are
quiesced until the process is complete.
NOTE: If no optional parameters are specified, the recreate snapshot command processes the specified
snapshot legacy virtual disks as a batch, provided a validation check of all of the virtual disks runs successfully. If
successful, the snapshots start the re-creation process and all of the affected virtual disks (snapshot, source, and
repository) are quiesced until the process is complete.
NOTE: The Microsoft Virtual Shadow Copy Service (VSS) provider allows the recreation of multiple snapshots
simultaneously.

Reduce Disk Pool Capacity

This command reduces the capacity of the disk pool by removing the physical disks from the pool.
Syntax
set diskPool [diskPoolName]
removeDrives=[enclosureID1,drawerID1,slotID1 ... enclosureIDn,drawerIDn,slotIDn]
Parameter
Parameter
removeDrives

Remove Remote Replication

NOTE: This command valid only with Fibre Channel storage arrays.
This command removes the replication relationship between the primary virtual disk and the secondary virtual disk in a
remote replication pair.
Syntax
remove remoteReplication (localVirtualDisk [virtualDiskName] |
localVirtualDisks [virtualDiskName1... virtualDiskNameN])
Parameter
Parameter
localVirtualDisk or localVirtualDisks
150
Description
Enclosure ID values are 0 to 31. Enclose the range of
enclosure ID values, the drawer ID values, and the slot ID
values in square brackets ([ ]).
Description
The name of the primary virtual disk (the virtual disk on the
local storage array) that you want to remove. You can
enter more than one virtual disk name. Enclose the virtual
disk name in square brackets ([ ]). If the virtual disk name