Table of Contents
Advertisement
Manufacture Cookie is not programmed.
1 Ethernet/IEEE 802.3 interface(s)
1 FastEthernet/IEEE 802.3 interface(s)
48 terminal line(s)
4 Channelized T1/PRI port(s)
128K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
4096K bytes of processor board Boot flash (Read/Write)
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
When the following message appears, press Enter to accept the default entry [yes] in
Step 18
square brackets:
Would you like to enter the initial configuration dialog? [yes]:
Step 19
When the following message appears, press Enter to see the current interface summary:
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
Ethernet0
FastEthernet0
Step 20
Enter a host name for the access server:
Configuring global parameters:
Enter host name [Router]: 5300
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter an enable secret password. This password is encrypted (more secure) and cannot be
Step 21
seen when viewing the configuration:
Enter enable secret: lab
The enable password is used when there is no enable secret
and when using older software and some boot images.
Step 22
Enter an enable password. This password is not encrypted (less secure) and can be seen
when viewing the configuration:
Enter enable password: guessme
Enter the virtual terminal password, which is used for remote console access:
Step 23
Enter virtual terminal password: guessagain
Respond to the following prompts as appropriate for your network:
Step 24
Configure SNMP Network Management? [yes]:
Community string [public]:
Configure LAT? [no]:
Configure AppleTalk? [no]: yes
Multizone networks? [no]: yes
Configure DECnet? [no]:
Configure IP? [yes]:
IP-Address
OK? Method Status
unassigned
NO
unassigned
NO
unset
Using Setup on Cisco IOS Releases 11.2 or 11.3(2)T C-11
Running Setup for Cisco IOS Release 11.3(2)T
unset
up
up
Protocol
up
Advertisement
Table of Contents
