Assigning The Ip Address To The Camera Using Arp Commands; Specifications - Sony SNC-M3W User Manual

Assigning the IP
Address to the Camera
Using ARP Commands
This section explains how to assign an IP address to the
camera using ARP (Address Resolution Protocol)
commands without using the supplied setup program.
Note
Enter the ARP commands within 5 minutes of the power
of the camera being turned on.
1
Open the DOS window on the computer.
2
Enter the IP address and the MAC address of the
camera to assign a new IP address, using the
following ARP commands.
arp -s <Camera's IP address> <Camera's MAC address>
ping -t <Camera's IP address>
Example:
arp -s 192.168.0.100 08-00-46-21-00-00
ping -t 192.168.0.100
3
When the following line is displayed on the DOS
window, hold down Ctrl and press C.
Reply from 192.168.0.100:bytes=32 time...
You will normally receive a reply after about 5
repetitions of "Request time out."
Note
If you do not receive a reply, check the following:
– Did you enter the ARP commands within 5 minutes of
the camera being turned on?
If not, turn off the camera and restart the operation.
– Is the NETWORK indicator on the camera flashing?
If the indicator goes off, the network connection has a
problem. Connect the network correctly.
– Did you enter the IP address previously used for
another device?
Assign a new IP address to the camera.
– Do the computer and the camera have the same
network address?
If not, set the same network address on the computer
and the camera.

Specifications

Web browser Internet Explorer Ver5.5 or
Image device 1/4 type CMOS
Effective picture elements
310 K pixels CMOS sensor
Built-in lens Focal length: f = 3.7 mm, Maximum F
View angle: 51.0° (horizontal), 38.9°
Shooting distance: 0.8 m to
Video compression format
MPEG4/JPEG (selectable)
Pan/tilt action ±60 ° (horizontal), +10 °/–60 °
Maximum frame rate
MPEG4: 30 fps (QVGA)
JPEG: 30 fps (QVGA)
Audio compression format
G.726 (40, 32, 24, and 16 kbps)
Protocol TCP/IP, ARP, ICMP, DHCP, DNS,
Network port 10BASE-T/100BASE-TX (RJ-45)
Wireless Lan (SNC-M3W only)
Utilization: IEEE802.11b
Built-in microphone
Electret condenser microphone
Mic input Minijack (monaural)
Plug-in-power supported
Line output Minijack (monaural), Maximum
Horizontal resolution
400 TV lines
Power supply 5 V DC
Power consumption
SNC-M3: 5.5 W
SNC-M3W: 8.2 W
Operating temperature
0 °C to +40 °C (32 °F to 104 °F)
Operating humidity
20 to 80 %
Assigning the IP Address to the Camera Using ARP Commands / Specifications
6.0(Available OS: Windows 2000/
XP)
number: F2.0
(vertical)
∞
(vertical), maximum speed 100 °/s
HTTP, FTP, SMTP, NTP
Frequency band: 2.4 GHz
Transfer speed: 11 Mbps, 5.5 Mbs,
2 Mbps, 1 Mbps (switchable
automatically)
Security: WEP (64/128 bits)
(omnidirectional)
(rated voltage: 2.4 V DC)
Recommended load impedance 2.2
k Ω
output level: 1 Vrms
41