Spanning Tree Tab - Global Stp - Linksys MGBLH1 - Gigabit LH Mini-GBIC SFP Transceiver User Manual

Root Maximum Age—Indicates the amount of time in seconds a bridge waits before sending
configuration messages. The default max age is 20 seconds. The range is 6 to 40 seconds.
Root Hello Time—Indicates the number of seconds a root bridge waits between configuration
messages. The default is 2 seconds. The range is 1 to 10 seconds.
Root Forward delay—Indicates the number of seconds a bridge remains in a listening and
learning state before forwarding packets. The default is 15 seconds. The range is 4 to 30
seconds.
Topology Changes Counts—Indicates the total amount of STP state changes that have
occurred.
Last Topology Change—Indicates the amount of time that has elapsed since the bridge was
initialized or reset, and the last topographic change occurred. The time is displayed in days,
hours, minutes, and seconds, for example, 2 days 5 hours 10 minutes and 4 seconds.

Spanning Tree Tab - Global STP

Configure the global settings for STP using this screen. Global settings apply to the entire
switch.
Spanning Tree State—Indicates if STP is enabled on the device.
Spanning Tree Type—Specifies the type of spanning tree used on the switch:
• STP—Spanning Tree Protocol (IEEE 802.1D); i.e., when this option is selected, the switch
will use RSTP set to STP forced compatibility mode).
SRW2024P User Guide
Using the web-based Utility for Configuration
Spanning Tree Tab - Global STP
86