Cisco PIX-515E Quick Start Manual page 31

Command
dhcpd lease 3600
Step 6
dhcpd ping_timeout 750
Step 7
dhcpd auto_config outside
Step 8
dhcpd enable inside
Step 9
Step 10 http 192.168.1.0 255.255.255.0
inside
Step 11 http server enable
Step 12 pdm history enable
Step 13 pdm logging informational 100
Step 14 write memory
Step 15 exit
Refer to the following website for detailed command information and configuration examples:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/index.htm
The Cisco TAC website is available to all customers who need technical assistance. To access the TAC
website, go to:
http://www.cisco.com/tac
Description
Specifies the length of the lease (in seconds) granted to
the DHCP client. The lease indicates how long the
DHCP client can use the assigned IP address.
Allows the configuration of the timeout value of a ping,
(in milliseconds), before assigning an IP address to a
DHCP client.
Enables the PIX Firewall to automatically configure
DNS, WINS, and domain name values from the DHCP
client to the DHCP server. If you specify dns, wins, and
domain parameters, then the CLI parameters overwrites
the auto_config parameters from the outside interface
of the firewall.
Enables the DHCP daemon to begin listening for DHCP
client requests on the inside interface.
Enables PDM access to all hosts on the inside network.
Enables an HTTP server for PDM access to the
PIX 515E.
Takes a data sample and stores the sample data in the
PDM history buffer.
Specifies the type and number of syslog messages
displayed.
Saves the modified configuration to permanent memory.
Exits the current configuration mode.
31